does anyone make poly urethane motor mounts for a 455

[455regal]

Hi
Does anyone out there know if anyone makes poly urethane motor monts for a 455 Buick. I checked energy suspention web site but didn't see any.
Thanks Brad

[BADDABUICK]

I thought HNRPARTSNSTUFF.COM WAS GOING TO PRODUCE SOME

[Kerry s.]

Hi Guys,

Brad.....Paul Ferry (owner of HRpartsNstuff) sent me a reply concerning the 455 poly motor mounts just last week.


Mounts are still a ways off. Working on a building & equipment setup before it gets cold again. Got to get setup for more production, or I will never get to the new stuff.

Thanks!
Paul Ferry (Owner/Pres)
HRpartsNstuff
2002 Industry Rd.
Atwater OH 44201-9354
Fax # : (330) 947-2977
Customer/Order Phone # : (330) 947-2433

I've been "on him" about them for the past couple of years now. He'll get around to them, I have NO doubts but it will help TREMENDOUSLY if more of the BBB guys drop him an e-mail about them! HRpartsNstuff@aol is his e-mail address or you could always give him a call at the above number.:TU:

[Leviathan]

There have been a few folks try the a method of drilling the mounts and putting in a safety bolt that runs through the rubber. In concert with a tie down cable you'll get a similar effect, not great, but about the best you'll get these days...

[455regal]

Thanks for the replies!! I ask because I built my own oil pan and messed up a little in measuring. It was 1/8 from the back of the crossmember on the corners. I pulled the motor ( 6th time!!!now) and cut and plated the crossmember. fits great now!!
Thanks again Brad