Maxi 4 cam

[VanHorn]

Has anyone used the Kenne Bell Maxi 4 cam, and if so, i would like to hear some opinions on it, and or results.

Thanks

[tommieboy]

Don't know anything about that cam. But its specs are listed on the following site. Looks like a big camshaft.

http://chicagolandbuick.org/partners/Charlie%20Evans%20cam%20tables.htm

[GSXMEN]

I had heard that cam was for a 'stock appearing' type car with iron manifolds - that would explain the large split favoring the exhaust side (duration and lift).

Will you be running Stage 1 iron heads or aluminum??

Headers??

Scott

[VanHorn]

scott


I am running stage 1 cast iron heads with some port work done. This is for a strickly race set up with open headers.



flow numbers
----.100-----.200-----.300-----.400-----.500-----.600
int. 69.3----140.7----214----- 261.4---267.8----267.8
ex. 61 -----117.6----157.5---188------203.7----208

[GS Kubisch]

12.5 to 1
TA 308s cam
Dominator
Your heads
In a well set up car (3200/3400lbs)
Should go mid ten's or better

[GSXMEN]

I wouldn't run the Maxi 4 cam with your setup. Like Gary suggests above, the TA 308 would be tough to beat!

Scott