Clutch chatter?

[Sturmgewehr]

Getting noise --sometimes-- with a new clutch--if I push the pedal in about 1/2"
it stops until I fully release it again. Can I adjust this out via the adjustment
rod linkage? Thanks Pete

[MPRY1]

Did you replace the pilot bearing/ bushing? If it's worn it will cause some chatter when the clutch is depressed.

[Adam C]

Hi Pete,
It's probably just the throwout bearing, mine does it too sometimes. You could tighten up the pedal free play a bit. How is the throwout fork and linkage, any worn parts? that will make it rattle also.
Adam.

[Sturmgewehr]

Hi Pete,
It's probably just the throwout bearing, mine does it too sometimes. You could tighten up the pedal free play a bit. How is the throwout fork and linkage, any worn parts? that will make it rattle also.
Adam. Thanks Adam---everything is all new---I might try adjusting
the "free play". Pete

[Chris Cornett]

It is the throwout bearing.Mine does it a bit but that is because I like the clutch to grab with minimal pedal travel.