GRIMM
03-18-2007, 02:05 AM
I figured this was the place to ask the question.
I am going to be running a holley 1000 HP on my 430 when its finished, so i was looking into the fuel systems, and decided to get the rail that you put one line into it and it curves it into bot front and back bowls
Then i decided it woul dget better flow, with my regulator which has one in and two outs, if i put one out to the rear bowl and one to the forward bowl, two seperate lines.
After this, i just decided it would be even better to just by two of the rail things that put one line to the front and back carb bowl inlets, put one on each side, and put one out from my regulator to each.
Would there be any benefit to any of these over another?
thanks
I am going to be running a holley 1000 HP on my 430 when its finished, so i was looking into the fuel systems, and decided to get the rail that you put one line into it and it curves it into bot front and back bowls
Then i decided it woul dget better flow, with my regulator which has one in and two outs, if i put one out to the rear bowl and one to the forward bowl, two seperate lines.
After this, i just decided it would be even better to just by two of the rail things that put one line to the front and back carb bowl inlets, put one on each side, and put one out from my regulator to each.
Would there be any benefit to any of these over another?
thanks