GS Fender Emblems question

[jaystoy]

Is there an easy way to install the GS fender emblems on my skylark without removing fender or inner fender? Obviously can't get nuts on them because I can't get inside the fender, do they make anchors of some sort to secure the emblem??

[Buicksky]

You can try finding barrel nuts that fit the post size of the emblem most fastener or body shop supply should carry them.Tony

[IDOXLR8]

Is there an easy way to install the GS fender emblems on my skylark without removing fender or inner fender? Obviously can't get nuts on them because I can't get inside the fender, do they make anchors of some sort to secure the emblem??

I think you can install the speed nuts from inside by removing the two lower bolts and few fender well bolts but be careful not to break the fender well stamped nuts and carefully check the door to fender clearance before and after doing anything for the body design has a peak that may make contact, AL.

[ibmoses]

3M emblem adhesive, just a dab.

Bert

[staged70]

I agree if its a clone just ghrind off the studs and use either adhesive or 3M makes a emblem 2 side tape that works very well.

[68 Skylark cust]

Hi , 3M (or other brand) won't comes off with rain or washing ??

[staged70]

All your new cars use 2 side tape. I mounted my cobra emblems on my 69 mach and for 4 years and many washings they held fine

[Joe65SkylarkGS]

Go to your local hobby store and get a roll of the clear two sided tape. This stiff will not budge during a tornado. It's generally used to hold in the electronics. And no matter how long it's on your car, you can always get it off the paint and emblem back without any damage or residue.

Best tape you can get.

If you can't find any, let me know.