350 conn rod lenght?

[Johnboy]

i'm testin combos for a 350/350hp,i'need the rod lenght for an 78 Buick 350 or the rod of the GS 350:confused:

[GSXMEN]

Welcome to the board.:TU: :beer

SBB rods are 6.380".

[Johnboy]

thanks dude i'll start form there,(rasin a BUD too yeah!):beer

[Johnboy]

they should hold at 6000 max rpm rite,in recondition form(new bolts etc.)

[GSXMEN]

Properly reconditioned rods with new bolts will last to 6k no problem!!:Smarty:

Don't forget a good balance job, and of course, the right 'Buick' oil clearances!!:TU:

The '73 & newer rods with the capscrews are generally recognized as the stronger of the bunch. I believe TA Perf. has new rod bolts/nuts for the '68-'72 style rods, so use of the earlier rods shouldn't make you nervous!!:grin:

[Johnboy]

thx again Scott,as i test i'd may want your input again, i'm testing using a PC Software to come up with some ballpark hp/torque #'s.i've built a SB and BB chevys before,this time i want somthin different,know what i mean?i'm in the middle of this 87 Buick Regal with a 78 Buick 350,4bbl and i'm shottin for 350-400 hp,what do u think?(opening 1 more :beer

[GSXMEN]

John - PC software like Desktop Dyno will definitely 'get you in the ballpark'....of course, there's nothing like some 'real world' combos that you can get from many guys here on this board!!:TU:

There are quite a few 'proven' combos that should give you at least the 350hp you're looking for.

*One word of caution re: building Buick engines - They don't like the typical clearances that most machine shops would normally use on Chevies, etc. Rods & mains HAVE to be kept tighter - .0015"-.002". Also, HV oil pumps on Buicks are generally a real NO-No!!

Best advice: Ask many questions!!:grin: :TU: We'll get you hooked up.:bglasses:

My brother put a '70 Buick 350 into an '81 Cutlass - had alot of fun with that car!! Your Regal sounds like a good project!!:TU: