Sheet metal repro question

[brians]

Does anyone reproduce the sheet metal at the bottom of the rear window?

By this I mean the portion of the body which traps all the moisture since the water cannot drain just below the rear window under the stainlesss trim.

Brian

[oPh]

Just for good measure, might compare this panel in a '70-72 Chevelle 2 door, as the decklids are the same.
:3gears:
Roger

[10sec 455]

Chevelle is completely different. I beleive buick has the only window that bows up in the back. All others bow down.
Jeff

[doc]

We neeeeed for somebody to tool up and make the lower rear qtr. panel sections for all the Buick 60s cars. You can find truck loads of them for chevys , pontiacs, olds ect. but none for Buick. I have a 65 lark and a 68 Riv and both need repair in that area. I guess I will have to hand make the panels. Doc