Have to prime my 2 Barrel

[Skylark69]

I have to prime my carb every time I start the the car even after it has ran a while, I still have to prime it to start it , any thoughs on what the problem is and how to fix it. Thanks

[John Eberly]

So you have to dump gas in the carb to get it to start. It's pretty common to have to pump the gas a couple times when a car is cold, but it should light right up when it's warm.

Hard to diagnose with only that info, but some things come to mind:
1. Non-functioning choke.
2. Accellerator pump not shooting gas.
3. Stuck float.

I would suggest that you start with a careful rebuild of the carburetor. You won't need any special tools, just get a good quality carb rebuild kit, take your time, and follow the instructions. Make sure you put in a new float - this probably won't come with the kit. Set all of the little clearances per the kit instructions - this is important.

You may have other problems too, but I'd start with a carb rebuild. Ask for some help if you don't think you have the skills - maybe somebody on the board is close enough to stop by and help you out.

[doc]

Do what John says and it will probably fix the problem. If it doesnt, then look at the fuel pump.

[Skylark69]

Thanks alot, now finding a rebuild kit , I know where a 4 door buick skylark is that has a 350-4, I think if I can get the intake and carb reasonable, I'll go that rought but I dont know how it has been setting so it will proably have to be rebuilt too.