PDA

View Full Version : 4150 Question (750 Cfm Vac Second)



RIVI1379
05-27-2005, 09:55 AM
ON THIS CARB MENTIONED ABOVE, CAN YOU REVERSE THE DUAL FEED LINE SO THAT THE INLET IS IS AFT THE CARB RATHER THAN THE FRONT. I PERSONALLY CANNOT PERCEIVE DOING THIS SINCE IT'S THE TYPE OF CARB IT IS AND THE IDLE CIRCUIT IS THE PRIMARY SIDE. WOULD THAT NOT FILL THE REAR BOWL QUICKER THAN THE FRONT? JUST ASKING (FROM AN ENGINE COMPARTMENT NEATNESS PERSPECTIVE.) THANKS IN ADVANCE. :3gears:

Jeff Kitchen
05-27-2005, 12:18 PM
If you're talking about just putting the "Y" type fuel line on backwards (rear facing), then that should be fine. It really won't fill one any faster than the other. DO NOT, however, put the float bowls on backwards. The accel pump holes won't work if you do.

Have fun.

GSXER
06-14-2005, 02:44 AM
I have had it rigged both ways makes no differance ...remember a good fuel pump is forcng fuel into carb at 5psi any way.