Rebuilt quick ratio gear box 145 shipped no core

Discussion in 'Parts for sale' started by CARHEX1, Jun 24, 2014.

Thread Status:
Not open for further replies.
  1. CARHEX1

    CARHEX1 Founders Club Member

    64-72 gm a body gear box quick ratio. 3 to 3 and 1/8 turns stop to stop #6 casting rebuilt no core needed 145 shipped anywhere in the USA. rebuilt in America from a used good low mile core. 90 warranty Hector Carrillo Carhex 626 488 5472 same gear box you see at swap meets for 275+
     
  2. Redmanf1

    Redmanf1 Gold Level Contributor

    Pics please
     
  3. CARHEX1

    CARHEX1 Founders Club Member

    sending in a few
     
  4. HotWired

    HotWired Well-Known Member

    In line would also like to see pics
     
  5. CARHEX1

    CARHEX1 Founders Club Member

    I have an unlimited supply kind of like the F41 bars that I get all the time. Do you have an email i can send you pictures to? Hector
     
  6. Tim

    Tim Silver Level contributor

  7. Da Torquester.

    Da Torquester. Platinum Level Contributor

    Actually I am in need of a steering box. My original has quite a bit of play now. Do these look like an original for a 71 GS Skylark ? My email is buick45571@gmail.com if you could also send a picture. Thank you. John B.
     
  8. CARHEX1

    CARHEX1 Founders Club Member

    just sent pictures thanks! do you think you could post them here for me please?
     
  9. 73-462GS

    73-462GS GS Mike

    Can you be a little more explicit about what "rebuilt" means please?
    Thanks,
    Mike D.
     
  10. CARHEX1

    CARHEX1 Founders Club Member

    they are all off of 68-72 gm a body cars and are the same. I part out cars for a living and found a good shop that I deal with that dose quality rebuilds. I hook them up with cores the hook me up with rebuilt units to sell. will send a pic in a few
     
  11. CARHEX1

    CARHEX1 Founders Club Member

    they dissemble inspect install full rebuild kit with bearings and seals.
     
  12. CARHEX1

    CARHEX1 Founders Club Member

    invoice sent will ship out tomorrow. Anybody else need one?
     
  13. Tim

    Tim Silver Level contributor

    I tried to post the pics you sent me but they will not work???
    Sorry
     
  14. CARHEX1

    CARHEX1 Founders Club Member

    ok thank you.
     
  15. GS Jim

    GS Jim Platinum Level Contributor

    Hector, I'll take One. As long as it'll fit on my '65 Skylark, I don't need no stinkin pictures. I know what they look like. Just as long as it works like new. PM me the particulars. Thanks Man.

    PONCH
     
  16. CARHEX1

    CARHEX1 Founders Club Member

    lol will do direct bolt in. if your car was a manual steering car all you would also have to change the rag joint. manual and power steering rag joints are not the same. will pm in a few thanks. hector
     
  17. CARHEX1

    CARHEX1 Founders Club Member

    pm sent to the few that posted interest. more are available Hector
     
  18. CARHEX1

    CARHEX1 Founders Club Member

    anybody else?
     
  19. Taulbee2277

    Taulbee2277 Silver Level contributor

    Hector,
    I'll hit you up here soon, I've been in need of one of these.
     
  20. CARHEX1

    CARHEX1 Founders Club Member

    ok
     
Thread Status:
Not open for further replies.

Share This Page