Hmmm, I'll check it out, but I can't seem to find any gear replacements for my msd pro bullet, PN 8548 anywhere......
Jegs or Summit did not have any listing for that gear when I bought mine. I called MSD direct to order, they should have a part number for that replacement gear by now. IIRC it was abt $35 - 45 shipped.
Yep, were pretty much on our own to "figure it out" I like being the underdog, the only way from there is up!
When I bought my MSD Pro Billet distributor Im pretty sure it came with the gear, and a stock gear would fit if needed
Yes you will need to call them. I bought a used Msd 455 Dist. Then I called Msd and bought a 350 gear for it.
What are you talking about? Replacement Distributor Gears TA 1400 350 Bronze, Points ...................... $35.00 TA 1400A 350 Bronze, MSD ........................ $45.00 TA 1400B 350 Bronze, HEI .......................... $45.00 TA 1402 350 Steel, Points ......................... $65.00 TA 1402A 350 Steel, MSD ........................... $69.00 TA 1402B 350 Steel, HEI ............................. $69.00
I guess I should have looked first? lol There is still not a lot of support for this motor, Heck I had my heads ported 24 years ago, you would have thought some aluminum heads would have been done before now. Those Ken Bell test are 30 years old and it just dies off after that. You still can't go down to Summit to get any parts for a 350. I got some there but not a whole lot. Nobody has matched Sonny Seal yet.