I need a good stock axle for an 8.5 10 bolt. Bolt in axle, not c clip. 28 spline 29 11/16” axle length from axle flange to end of axle. Passenger side if that matters. Thanks!
We have a loose passenger side (if it even matters) axle left over from when we broke the drivers side. Has miles and lots of runs...but its all there. Need to measure when I get home tonight... where are you located? D.
Jim, I have a bunch of axles. Email me direct and we'll see if I can help you out. drolds1@bellsouth.net. I'm in South Florida. Thanks, Bob.
the one we have is a moser, passenger side complete with bearings... again, I'll measure it up a bit later
29 3/4 from outer flange to end.just been sitting in the garage with it’s broken sister. I’d want to install a new bearing and matching race if I was using it.
They are interchangeable,I do have it if the other guy's can't help you. I wrote this hours ago,forget to punch it in.Bruno.
We had a Moser axle shatter that way, all jagged and rough. Axles usually shear clean, like cut with a blade. That one is the result of improper heat treat.
I really only need a stock axle. Save that one for someone that needs a beefy one. But thank you for the offer.