64-72 GM A-body 12-bolt Chevy 3:73 1969 Chevelle 12-bolt housing,tubes welded,ends cut off and narrowed 1/2” on each side,Moser #7900 ends welded on,blasted & powder-coated. Motive Performance 3:73 gears TruTrac 33-spline posi unit Moser 33-spline shafts with 1/2”x3” studs Timken bearings/seals Strange steel 1350 yoke TA aluminum girdle cover Assembled,filled with fluid and ready to run. Backing plates are included. Just add you brake hardware. Price is $2600.00 plus freight.
Im interested.. will this bolt in my 1970 gs455 ? Can i swap my CCP C5 12 inch disc brakes from my existing stock rear with out problem? I would imagine all will work.. shipping would be to 33460
Stump Puller455, The Moser #7900 ends have the same GM flange pattern for the original backing plates or similar disc brake setups. You may or may not have to tweak or modify the caliper brackets,depending on how they are mounted,but I can give some insight on that. I installed a few different disc setups on these housing ends. If you still have your original 8.2” rear,you will need an adapter u-joint that has the 3R size for your driveshaft and the 1350 size for the axle yoke.
I still have the original 8.2 ... the ends on your 12 bolt look like mine....brakes should swap can you quote shipping to fastnal 7656 Byron drive Riviera beach fl 33404 ... thanks Brian
The actual bolt pattern on the flange IS the same. The bore is larger for the big SET20 bearing.I will get a quote in the morning.
$200.00 to get it there,so total would be $2800.00. If you are installing rear discs,I can remove the drum plates.
Do you remember if your caliper brackets mount OVER the housing end,or do they mount to the face and act as a retainer plate for the bearing? Just trying to help out as much as I can on my end. I’m that guy that gets a bunch of parts dropped at my feet and told “make this work”.
Ok. Much easier. The ones that mount OVER the housing end are like a C-shape,and they need opened-up to fit over the thicker end. Does your bracket have a circle/pocket machines in it,where it presses against the seal,or is it flat?
Its a circle pocket ... it bolts to the 4 holes on the end of the axel this brake kit is cpp c5 13/12 inch rear rotors
Hopefully I can use my brakes got a lot of money tied up in them. otherwise i’ll have to get out of line.. I appreciate your help Figuring out whether they will work or not when you get time just let me know and we’ll figure out payment when I get home in the afternoon I could pull the rear tire off and caliber rotor and send a photo