I think it's 1/2". But can't swear. The new one I just got from th local big box was very hard to fit into the grommet from ta, if I would had been thinking I would had just ordered one with it and the intake
Thanks. Anyone who knows the size of the other end of the pcv valve? It's stuck in the grommet so I can't measure myself.
Outlet End Outside Diameter = 0.440 IN (= 11.18 MM) Outlet End Outside Diameter = 11.18 MM (= 0.440 IN) So it's the same size on both sides even if the pictures shows two sizes? Dorman Groomet: Inside Diameter (in): 0.418 In. //Just noticed that the PCV valve picture doesn’t have the right stamp.
No, .440" = 11.18mm. There is 25.4mm in 1 inch. That is the side that goes into the grommet. The other side goes into the 3/8" I.D. hose (.375") I'm not sure what you are trying to figure out with this thread? The PCV is a tight fit in the grommet. It is meant to be that way.
I would like to try the Dual Flow PCV valve from M/E Wagner. But it has 3/8” connections on both sides and our intake manifold pcv grommets are 7/16”. (Intake manifold hole = 0.94” wide and 0.18” thick) Would it be possible to find matching grommet or do I have to make an adapter?
You LIKE the idea of buying a hundred-plus-dollar PCV valve? Can I supply you with special $50 PCV filters and $75 PCV hose?