1967 gs convertible

vonwolf, here is a pic of the ac firewall. that may help. there is no reservoir on the 67. also the vacuum diaghfram has the nipple broken,but I should have another. I'll sell the lines and grommet and a good vac dia. for 50 shipped unless you need more than that. . Wacko

 

I was looking at the 45-4600 pa so yiur right no reservior, I am uploading the page from the Chassis Manual and circled i red the parts I neeed and a blurry picture of the 4 war block I need and the hoses that connect to the other side that I can't find any where. Let me know if these parts are available.






Thanks

 

I have nearly all parts from my old 66 skylark as well.

 

Have you decided if you'd be willing to sell the dash vents???? I don't see anyone else speaking up for them... ray:

 

I am interested in the rear seat and rear interior side panels. thanks

 

What does the trunk emblem look like?

 

Wacko,headlight doors? Available?Condition? Thanks! Archie

 

I have taken the dash out and all the firewall ac stuff off. vonwolf do you need the hoses on the engine side or dash side ? 67skylarkvert I have some round dash vents $75 shipped. my66lark the rear seat is very good but the upholstery is wrong $300 plus shpg. the upper rear interior panels $75 shipped. jet the trunk molding is gone . gokitty the hl doors are pretty pitted, Wacko

 

Wacko,thanks for the reply. I'll pass this time. Archie

 

Any chance you could post a picture or 2 of the vents, or email to me? aleidholm@triad.rr.com

 

I need the Engine compartment side, the parts I have circled in red, that 4 way rubber Block I have in that fuzzy picture and the vacuum lines that run after the block. To be honest it was a while ago that I took it apart so I'm not really sure how long they are?

 

vonwolf and 67skylarkvert, i'll get some pics, Wacko

 

Does it have the 4 way power bench seat? If so I am interested in the drivers side seat mount.

 

I am NOT LOOKING FOR ANY AC PARTS! But I am looking for the aluminum power steering bracket, the retainer brackets that hold the heater hoses on the passenger side of the engine, as well as the battery tray if it's in decent shape. Would be interested in the kick panels too. Thanks.

 

how are the inner fender wells

 

In line for an A/C dash pending pics and availability.

 

the inner fenders are rust-free. $150 for the L and 200 for the R. How much of the dash do you need ? all the gauges, wiring and controls or just the chrome dash bezel ?

 

Looking for a wiper motor and washer fluid pump. They available?

 

I just need the chrome bezel with the A/C vent above the radio cutout.
thanks

 

you have a PM , I need a nice trunk rear horizontal trim piece that is not broken or full of pit marks