Does anyone have a picture of the upper control arm/vernier bolted together at the correct pinion angle. I will check final pinion angle later once I have the body back on the frame. Thanks in advance
Hey Briz Thanks for responding. I love your Riv by the way. It’s awesome! Rereading my post... I can see that I wasn’t very clear. I am just looking for a pic of the single upper rear control arm that bolts from the frame to the rear axle. There are two halves that are bolted together with three bolts. two bolts go thru slotted holes and the third runs thru a hole that aligns for the angle of the axle. Kevin
Sorry I had forgotten about this. I forget lots of stuff these days. This is a pic of the set up currently installed on my 68.