70 Buick Electra 2 dr Convertible parting out.

Discussion in 'Car Part-Outs' started by David A Davis, Dec 3, 2019.

  1. David A Davis

    David A Davis New Member

    Picking up the car from an auction. I needed parts for my Wildcat and selling the rest. The car has a salvage title with very minor damage to the right front. Otherwise in well above average condition. If anyone is interested in parts, please email with requests. Thanks.
     
  2. ajesh35

    ajesh35 Well-Known Member

    Pic of steering wheel
     
  3. 66electrafied

    66electrafied Just tossing in my nickel's worth

    Does it have Cruise control? I'd need the whole works.
     
  4. mrh

    mrh Well-Known Member

    does it have an am/fm radio? if so, how much?
     
  5. BBBPat

    BBBPat Well-Known Member

    Needed; the countersunk sheet metal wing nut that secures the round masonite spare tire cover. PM me here please.
     
  6. RonL4760

    RonL4760 New Member

    Folks I have a 1970 Wildcat convertible and am in search of RH (passenger side) cornering lamp chrome trim bezel, or whole fixture. ‘69 will fit; of course LeS/Electra too. Would appreciate any leads or sources. Many thanks.
     

    Attached Files:

  7. flynbuick

    flynbuick Super Moderator Staff Member

    You need to start your own thread in the parts wanted section. Then, we will delete this post.
     
  8. pphil

    pphil Well-Known Member

    Where are you located?
    I may need a passenger door

    Scott
     
  9. RWW369

    RWW369 New Member

    hi, can you advise. i need a body sheet metal parts if in good condition and available; ie hood, trunk lid, both right and left doors for 2 door coupe. let me know.
     
  10. gsx455-4ever

    gsx455-4ever Gold Level Contributor

    Where the heck were you a year ago ??? I tried selling a NOS RS door . Had it listed for like 2 years . I finally scrapped it . Plus a used LS door complete .
     
  11. gsx455-4ever

    gsx455-4ever Gold Level Contributor

    Plus the last time this original poster was on was Last Christmas .
     
  12. newmexguy

    newmexguy Well-Known Member

    Yep I had access to sheetmetal from this '69 Electra for almost three and a half years. It finally went to scrap 6 - 8 months ago. Didn't dare buy anything large from it (due to shipping hassles) did sell the fenders pre paid went by Bus.
     

    Attached Files:

Share This Page