Had my neutral safty switch go out and, for once, i had the time and money to spare so seeing as how almost every other aspect of the column is busted i figure id swap in a new one. Having a hell of a time finding a suitable one however, so i was hoping some of you fine folks on here might know what other cars i could pull from. 71 skylark, 3spd column, no cruise control, no tilt
You may want to specify tilt or non tilt. Also send Brian Trick on this Board a pm. He rebuilds steering columns.
awsome thanks, i put non-tilt above but i doubt ill be able to afford a proper rebuild (wish i could)
I have a complete column with wheel . I believe I have it in parts for sale. I won't be able to send pictures till Sunday. Non Tilt
https://www.facebook.com/groups/570...41675869233570/?sale_post_id=2241675869233570 This is it . Where are you located ? Shipping would depend a lot on that .
Loomis CA, i was thinking about the shipping, its why i was hoping i could use a column from something else
Ok,you need a non-tilt. Do you need a column-shift,or one for a floor/console shift? I have shipped them from Pennsylvania to California for less than $40.00
I don’t ship them with a steering wheel or intermediate shaft. I like to use some of my leftover Moser axle boxes to ship these. Nice a sturdy,and have room to pack material around the column.
I ship mine FedEx ground. I have an account,which makes it a little cheaper,and if you print out the shipping label,it is even cheaper yet,compared to just writing the info on the box. I also have a UPS account,but I rarely use it because FedEx is almost always cheaper. I shipped a 70 rear bumper to Tacoma Washington for $80.00. That’s hard to beat.
