72-Pinchweld molding clips

Discussion in 'The ragtop shop' started by Skylard, Oct 31, 2019.

  1. Skylard

    Skylard Well-Known Member

  2. pglade

    pglade Well-Known Member

    You shouldn't need any of the clips at all.....all the '70-72 Abody converts I've messed with have the pinch weld molding held on with JUST SCREWS. There are holes in the underside lip of the pinchweld molding where the screws go through.

    I guess you might be able to use those clips if you want to be able to remove the molding a bit easier after it's been installed but again, I don't believe the factory used them from '70 on.
     
  3. Skylard

    Skylard Well-Known Member

    Thanks that helps a lot.
    Much appreciated!
     

Share This Page