A6 Compressor - Replace Pulley Bearing

Discussion in 'The Big Chill' started by JZRIV, Jul 13, 2015.

  1. JZRIV

    JZRIV Platinum Level Contributor

    Can the pulley be pulled on an A6 compressor to replace bearing without dumping the charge? Seems to me it can but not sure. Bearing is a little noisy.
    Thanks
     
    JZRIV, Jul 13, 2015
    #1
  2. GSX 554

    GSX 554 Gold Level Contributor

     
    GSX 554, Jul 13, 2015
    #2
  3. JZRIV

    JZRIV Platinum Level Contributor

     
    JZRIV, Jul 13, 2015
    #3
  4. GSX 554

    GSX 554 Gold Level Contributor

     
    GSX 554, Jul 13, 2015
    #4
  5. Briz

    Briz Founders Club Member

    Good luck with that snap ring. Its way down in there.
     
    Briz, Jul 13, 2015
    #5
  6. telriv

    telriv Founders Club Member

    Make sure you take notice if there are ANY shims behind the pulley whjich set the "Air Gap" on the clutch.
     
    telriv, Jul 13, 2015
    #6

Share This Page