2 groove billet crank Pulley for 400/430/455 big blocks. Bolted to a balancer but never used. Never even had a belt put on it. A few marks around the holes from the bolt heads, not visible once installed. $70 shipped to lower 48.
Shawn, Was that a TA part, or do you mind saying where it was originally purchased? If you happen to know.... Thanks
Phillip I used a cvf 2 groove pulley on mine, worked great, was a smaller diameter so it got the belt away from my electric water pump.......with the factory pulley the alt belt would slightly rub enough to leave a mark on the motor. https://www.google.com/amp/s/www.cvfracing.com/amp/buick-400-455-crankshaft-pulley-2v/ They have a 3 groove for similar money. not sure if this is the same as the one posted or not, but the part number is the same if you zoom in to see it in his picture. But not sure if TA sells them or not
Hi Philip, Ben is correct, this is indeed a cvf. I don't 100% recall where I bought it, but I know it wasn't TA, it was likely directly from cvf based on the paperwork. Through a boondoggle I bought two at separate times forgetting about the first one I already had.