Copper Gaskets

Discussion in 'High Tech for Old Iron' started by Briz, Mar 27, 2020.

  1. Briz

    Briz Founders Club Member

    Mainly for the header flange and collector gaskets. Spoke with Tim @ TA today and they dont carry or know of any manufacture. Have been running Remflex and they are great! . However every time I pull the engine the gaskets rip no matter how careful I am to take them off in one piece. Another member mentioned that he uses copper flange gaskets so I started thinking. If no one is making what I need I can make my own if I find a supplier of the material. Thoughts?
     
  2. telriv

    telriv Founders Club Member

    Once you buy the material nec. & cut/shape to what you ant you will need to make it "dead Soft".
     
  3. Bens99gtp

    Bens99gtp Well-Known Member

  4. Mike T

    Mike T Well-Known Member

  5. Briz

    Briz Founders Club Member

  6. Bens99gtp

    Bens99gtp Well-Known Member

    I refused mine many time......just cleaned them off sprayed them with copper coat, I did 3 coats....the slid them in
     

Share This Page