Electric choke conversion for 4MV divorced choke?

Discussion in 'Street/strip 400/430/455' started by BuickSpecial41, Apr 14, 2017.

  1. BuickSpecial41

    BuickSpecial41 Well-Known Member

    Hey everyone,
    I recently acquired a 71 Buick Riviera and am replacing the stock intake with an Edlebrock Performer. Does anyone know where I can find the electric choke conversion kit to replace the divorced choke? I need it pretty quick as I'm trying to get ready for a car show in two weeks. Any help will be greatly appreciated.
     
  2. flynbuick

    flynbuick Guest

    One of the carb guys on this Board developed one.
     
    BuickSpecial41 likes this.
  3. BuickSpecial41

    BuickSpecial41 Well-Known Member

    If you can point me in his direction, I'll gladly purchase it.
     
  4. LARRY70GS

    LARRY70GS a.k.a. "THE WIZARD" Staff Member

  5. HotRodRivi

    HotRodRivi Tomahawks sighted overseas

    It's pretty easy , wrecking yard , electric choke Assy , mid 70s, primary throttle shaft and everything attached to it,also get the bushing with the choke shaft seal, get the arm and rod up to butterfly and get that too. Take the pull off and sec vac break too. I remove the metal pot from the bracket, get a half plastic and metal pot . Solder it to bracket . Space it outwith another bracket that you cut. And it only cost Door fee. The Rochester is awesome, I can be cut and pasted pretty much in any combo u need
     

Share This Page