Got A good deal on two 430,s today

Discussion in 'The Bench' started by Dwayne B, May 17, 2019 at 5:23 PM.

  1. Dwayne B

    Dwayne B Well-Known Member

    Me and my dad went to A swap meet this morning and A guy had A bunch of stuff on A poster for sale.I just couldn't past up A deal on two BBB 430 motors for 50$.My dad bought 10 sbc,s motors that had been in A barn since the late 60 s,very cheap.
    So next week end me and him are taking A low boy trailer and driving about two hours away to get our motors.
    20190517_173347.jpg
     
  2. Bens99gtp

    Bens99gtp Well-Known Member

    smoking deal, the one in the front picture has the big port heads on it
     
    Dwayne B likes this.
  3. Dwayne B

    Dwayne B Well-Known Member

    Hey thanks, I didn't need them but to good of A deal to pass up.How can you tell it has the big port heads ,I don't know A much about 430,s.
     
  4. Bens99gtp

    Bens99gtp Well-Known Member

    every big port 430 I have tore apart had that funny runner above the exhaust ports .....there is cast flanges thete but they are not drilled and tapped. wish I knew what they were going to do with those. sure someone out there know.
     
    Dwayne B likes this.
  5. Dwayne B

    Dwayne B Well-Known Member

    Ok thanks for the info, I like to learn as much as I can.
     
  6. hugger

    hugger Well-Known Member

    It was going to be for AIR injection iirc, but yes 98% of the heads with that runner are the big ports "2985" is one casting #
     
    Dwayne B likes this.

Share This Page