Im looking for a 67 GS convertible frame

Discussion in 'Parts wanted' started by GSport67, May 7, 2018.

  1. GSport67

    GSport67 New Member

    Looking to replace the frame and I wanted to see if there were any out there. I'm in South Florida
     
  2. Black69Judge

    Black69Judge Well-Known Member

  3. 36racin

    36racin Platinum Level Contributor

    I have a 66 Special frame in Baton Rouge, Louisiana area. Not boxed. Manual trans car.
     
  4. buick67gs

    buick67gs Well-Known Member

    3speed or 4speed do you have any drivetrain parts
     
  5. 36racin

    36racin Platinum Level Contributor

    3speed column shift. 225 V6
     
  6. skybird300

    skybird300 Active Member

    I'm preparing an ad to part a 67 gs400 convert if you haven't located a frame lmk. Alabama Car rolling. Thx.
     
  7. philbquick

    philbquick Founders Club Member

    Kooch has a 66 GS he is going to part out. Unfortunately it just went from the Tampa area to Pa.
     
  8. 2dtrak

    2dtrak Member

    I know of a 67 skylark conv frame in southern Illinois if your still looking , I just removed some steering components off of it a few weeks ago
     
  9. Black69Judge

    Black69Judge Well-Known Member

    I am parting 4 67 GS's kinda ruff ones but still some good parts left 3 converts 1 not shown ..

    I have a Nice freshly blasted and por 15 frame I will be selling ... but .... I am in Seattle ..

    20six-465 9165

    Scott
     

    Attached Files:

    Last edited: Aug 9, 2018
  10. buick67gs

    buick67gs Well-Known Member

    price for 67 convertible frames, also do you have any 67 gs 3speed manual parts or know of someone with parts
     
  11. buick67gs

    buick67gs Well-Known Member

    need rocker moldings and conv. top frame
     
  12. buick67gs

    buick67gs Well-Known Member

     
  13. skybird300

    skybird300 Active Member

    Have 2 top frames and extra pieces. 1 is 65 in extra nice condition, 2nd is on the 67 GS400 car not rotted but was in barn with bad roof a couple of middle bows bent but i have extra to replace. LMK which one you would be interested in. Thanks.
     
  14. skybird300

    skybird300 Active Member

    Also, the moldings on the car have extra screw holes so if you're still interested LMK.
     
  15. skybird300

    skybird300 Active Member

    Chassis available with or without Posi 3.08 gearset towable on tow dolly or i can remove rearend to keep cost down. From the 67 GS400 Convertible.Thx.
     
  16. marxjunk

    marxjunk Well-Known Member

    67 is a 1 year frame..(technically)
    they are ready to accept a 400 turbo, and the rear spring perches are for the double pig tail coil on both ends of the springs..64-66 had a pig tail on the rear end and a huge open coil on the frame side...
     
  17. skybird300

    skybird300 Active Member

    Great info! Thanks!
     
  18. 36racin

    36racin Platinum Level Contributor

    Don't have either
     

Share This Page