Installed new gauges

Discussion in 'Interior City' started by Cutlass, Jul 31, 2019.

  1. Cutlass

    Cutlass Platinum Level Contributor

    Just finished installing three additional gauges, engine oil pressure, water temp and voltage.
    Started with a cardboard mockup of a box shaped housing and decided that I rather go a little bit curvy.
    Front panel is made of wood, gauges are recessed (using router), housing is made of 0,7mm aluminum. The top bracket is fastened with the existing screw dash/panel. For the lower bracket I had to drill two holes. My tape player will move an inch or so to the right.
    Next I need to borrow a can box, so that I can program the gauges (light color, trigger points for warning lamps, ...)
    IMG_2420.JPG IMG_2424.JPG IMG_2425.JPG IMG_2427.JPG IMG_2430.JPG IMG_2433.JPG
     
    Electra Bob and TrunkMonkey like this.
  2. TrunkMonkey

    TrunkMonkey Well-Known Member

    Das sieht gut aus!
     

Share This Page