Is theLunati h230-240 cam any good?

Discussion in 'Street/strip 400/430/455' started by 1970stage1455, Mar 29, 2020.

  1. 1970stage1455

    1970stage1455 Well-Known Member

    As most of you know i got the kenne bell engine and the mark C cam isnt what im looking for, However i want to get a c107 cam but i have a lunati part# 33304 grind # H230-240 sitting around that's new in box and was wounding if anyone else was running the cam and how it sounds? Also im running a kb149 switch pitch trans stalls at 3k at idle
     

    Attached Files:

  2. LARRY70GS

    LARRY70GS a.k.a. "THE WIZARD" Staff Member

    Looks like a nice cam. Very similar to a TA288-94H, (230/240, 114LSA, .488"/.488")

    LunatiH230240112.JPG
     
    ranger likes this.
  3. hugger

    hugger Well-Known Member

    Will have a pretty mild idle,...nothing like a 107
     
    ranger likes this.
  4. Thumper (aka greatscat)

    Thumper (aka greatscat) Well-Known Member

    I have a new 107 cam we ground a while ago on a 112 lobe center. Same specs except LC.
     
  5. Bens99gtp

    Bens99gtp Well-Known Member

    I ran this exact cam for many years, ran low 12 and upper 11s on a stk 70 bottom end.......that we just garage refreshed, no machine shop work.......mild ported small valve heads off 360 intake and edelbrock 750, 3000 stall, 4.10 gears........my car has always been manual brake so i dont recall how much vacuum at idle it has.

    I still have this cam......I enjoyed it very much.....it pushes the limit of stamp steel rockers though..... we did destroy a few and a few shafts till we put a 430 set of shafts on
     
    britt'sStage 1 and 1970stage1455 like this.
  6. David Shuwaloff

    David Shuwaloff Buick lover

    I’m running a lunati cam 10960701 in my 72 455 that is punched to 464 sounds pretty good
     

Share This Page