Metco Motorsports

Discussion in 'Race car chassis tech' started by hugger, Sep 24, 2019.

  1. hugger

    hugger Well-Known Member

    20190924_205811.jpg Just a reminder for you guys Metco Motorsports manufacturers the absolute best rear control arms for our 64-72 chassis while they may not be "light" the quality is unsurpassed by any other supplier and priced VERY competitively. Be sure to stop by their tent at the GS Nationals and say hi and remember that they are also Buick enthusiast.
     
    Last edited: Sep 24, 2019
  2. hwprouty

    hwprouty Platinum Level Contributor

    Sweet!!
     
  3. Mart

    Mart '71 350 GS, almost stock

    Nicer than stamped steel. Do they sell adjustable uppers?
     
  4. hugger

    hugger Well-Known Member

    Yes and they are BULLETPROOF
     
  5. hugger

    hugger Well-Known Member

  6. BrianTrick

    BrianTrick Brian Trick

    Adjustable lowers too?
     
  7. hugger

    hugger Well-Known Member

    They dont offer Adjustable lowers,..they should look into them tho. I'll run the fixed lowers as I'll be able to adjust my IC with the mounting points and not the length,..they just too sexy no to use and at $280 come on man. I really like spherical for all out race but for a street/strip deal these are it imo
     
  8. Skyhawk

    Skyhawk Well-Known Member

    HRPARTSNSTUFF has adjustable uppers & lowers & with their sway bar you can't go wrong.
     
  9. hugger

    hugger Well-Known Member

    Paul's stuff is very nice also no doubt,.I have a HR full setup on my brother's car actually
     
  10. BrianTrick

    BrianTrick Brian Trick

    I don’t play around with pinion angle. I use the adjustable uppers and lowers to pull the whole rearend forward some,without making it look goofy in the wheel well. All of my rears either have the raised upper ears,or in some of my stock restos,I made some solid blank bushings,for the upper ears,and offset-drilled the hole,to help bring the instant center back. It’s not much,but every bit counts.
     
  11. hugger

    hugger Well-Known Member

    The best bang for buck on uppers are the TRZ at $200,..but 1000yrs from now,..someone will dig up the Metcos during an excavation and they'll still be in good shape ha
     
  12. LARRY70GS

    LARRY70GS a.k.a. "THE WIZARD"

    I have the upper and lower Metco arms. Adding the lowers helped me hook better at the track. Very high quality parts and I have nothing but good things to say about them.
     

Share This Page