Mickey Thompson headers

Discussion in 'Street/strip 400/430/455' started by scubasteve455, Aug 11, 2019.

  1. scubasteve455

    scubasteve455 Well-Known Member

    Can someone give me the measurements. For the header mounts. Where the dip stick might be. If i need to cut or dremel. Is this gonna need to be taken care of before i install?
     
  2. scubasteve455

    scubasteve455 Well-Known Member

    And maybe a pic. If you have one. Thanks.
     
  3. hugger

    hugger Well-Known Member

    All the MT's I've had were clearanced via a scallop
     
  4. scubasteve455

    scubasteve455 Well-Known Member

    What about transmission return lines?
     
  5. scubasteve455

    scubasteve455 Well-Known Member

    Will they be in the way?
     
  6. LARRY70GS

    LARRY70GS a.k.a. "THE WIZARD"

    Nothing you can't remedy by bending the lines a little. I'd run push lok hose through the frame.
     
    Mike B in SC likes this.
  7. scubasteve455

    scubasteve455 Well-Known Member

    Thanks Larry
     
  8. hugger

    hugger Well-Known Member

    I'd suggest running an Lt1 starter and if using the stock lines I'd wrap a heat jacket over them there over the cradle,..the headers will actually sit on the lines putting un wanted extra heat in the fluid
     
  9. STAGE III

    STAGE III Lost Experimental Block

    Or wth just put in a 4 speed simple enuff:D
     
    Brett Slater likes this.
  10. LARRY70GS

    LARRY70GS a.k.a. "THE WIZARD"

    Or run lines through the frame.
     
    john.schaefer77 likes this.
  11. scubasteve455

    scubasteve455 Well-Known Member

    John I have a fortune in that B.B. Your a funny guy.
     
  12. scubasteve455

    scubasteve455 Well-Known Member

    Seen those Push loc on Ebay. Tomorrow i will buy a kit
     
  13. scubasteve455

    scubasteve455 Well-Known Member

    Don’t wanna burn up my converter .
     
  14. scubasteve455

    scubasteve455 Well-Known Member

    Yes my starter looks to big now
     
  15. 69 stepchild

    69 stepchild New Member

    AFB896B5-2ECA-4384-827D-96F9EA9308CB.jpeg 5BDCE0C6-2D9B-4F65-BA10-296CCECC8682.jpeg Here you go...had to clearance the flange and use the dipstick with no tube style for my 73 block.
     
    scubasteve455 and Mike B in SC like this.
  16. scubasteve455

    scubasteve455 Well-Known Member

  17. scubasteve455

    scubasteve455 Well-Known Member

  18. scubasteve455

    scubasteve455 Well-Known Member

  19. scubasteve455

    scubasteve455 Well-Known Member

    I asked you guys if this was gonna be Difficult.
     
  20. scubasteve455

    scubasteve455 Well-Known Member

Share This Page