MSD Super Conductor plug boots - snug fit!

Discussion in 'Street/strip 400/430/455' started by Electra Bob, May 22, 2020.

  1. Electra Bob

    Electra Bob Well-Known Member

    So I got going on on the Hyperspark upgrade and started checking new plug wire routing.

    I purchased a set of custom fit MSD Super Conductors with straight plug boots and oh boy neighboring cylinders are not socially distancing! Is the constant flex of the boot and or proximity going to be an issue?

    Cheers
    Bob

    MSD Super Conductor boots 1024.jpg
     
  2. LARRY70GS

    LARRY70GS a.k.a. "THE WIZARD"

    Those are multi angle boots. Don't be afraid to bend them.:)
     
    Mark Demko likes this.
  3. hugger

    hugger Well-Known Member

    120 or 45 degree boots are much better,..Taylor wires are a great wire for much less $

    Number 8 is no fun even if you bend it they only go so far
     
  4. Cutlass

    Cutlass Platinum Level Contributor

    Glad you asked, I had the same question, but did not dare to ask :)
    IMG_0325.JPG
     

    Attached Files:

    Mark Demko likes this.
  5. Electra Bob

    Electra Bob Well-Known Member

    Hmmm - so as I understand the way the internal metal connector is formed there is a logical hinge point about mid way. How do you determine that when it is encase in the boot? Is it always oriented with respect to the MSD molding?

    Cheers
    Bob
     
  6. Briz

    Briz Platinum Level Contributor

    My MSD boots fit about the same way and have no problems
     
  7. LARRY70GS

    LARRY70GS a.k.a. "THE WIZARD"

    I just bend them the way I want them. Haven't had a problem.
     
    Mark Demko likes this.
  8. Mark Demko

    Mark Demko Well-Known Member

    IMG_0573.JPG Yep bend them suckers:D Been running MSD wires for years, no issues. Taylor is good too.
    Im not sure if theres a proper way to bend 'em, but they position pretty easy, just don't get crazy moving them around.
     
    Last edited: May 24, 2020 at 7:07 AM

Share This Page