Devon, I received your message. I havent made sets for a few years...my former vendor that cut, formed, welded and polished these for me for past 23+ years, closed up shop... still kinda looking for a new vendor. There is a lot of work involved, however it is very difficult to find any place these days that doesnt want to charge me a $500+ per set.... ugh. Wheelz, Tampa Bay
I had my N-25 tips cut off at 2-1/2" dia., then welded a 2-1/2" section of tailpipe on to have a true 2-1/2" system all the way. You might be able to take a set from Parts Place and cut them at the 3" dia. mark, and do the same..... Retain the original appearance, you can't see the welds from behind. https://rover.ebay.com/rover/0/0/0?mpre=https://www.ebay.com/ulk/itm/271340649866