Parting '65 Skylark 4dr sedan

Just finished disassembly of a CA fresh 4dr, would prefer your want list. Body was beat but has lots of the small goodies, complete 355 with St300 ready for pick up. Factory A/C car. I am somewhat new to these postings so kinda bear with me, I will do my best to respond. The parts are in Sacramento, CA.. no rust country. Thank you in advance, Gary

 

Looking for the plastic trim that goes around dash, mine is in pieces.

 

I need 14 inch arm rests from front doors.

 

PM sent

 

does it have the cast iron 4 barrel intake manifold?

 

Hi .I'm looking for the lowest 3-4 inches of the inner rear fender wells .I put a new trunk pan in and had to cut away the wells where they meet the trunk pan.

Both sides I need.

 

I do have the plastic trim that surrounds gauge cluster. Upper left is broken, can be repaired, also upper center area has small piece missing.
Can you PM me for pix? Item w/shipping in CA $28 total. Thanks, Gary

 

Arm rests are gone, but have lead on more I may be able to pick up soon. Will update you later. Thanks, Gary

 

Phil, The car was parted, then the chassis/body had to be moved and went to scrap crusher before I could get all the good sheet metal. Thanks for
asking. Gary

 

I do have the original intake with 4bbl carter carb. and A/C, selling as pkg. only..., $450 + grnd ship to US address only. You are first to ask, let me
know. PM me for pix.? Thank you, Gary

 

Hi Joe, Sorry but car body/chassis was sent to scrap before I could get to the sheet metal, all was good. Thanks for asking, Gary

 

How about the rear compressor bracket that goes from the compressor to the intake manifold?

 

Cool.

Thanks anyways pal

 

Thanks,you can PM if you find any,Dan

 

Looks like some nice work on the trunk floor Joe.

 

Phil, All brackets are gone,,