Proceeds to supporting board - Speedway Fuel Link for EFI sending unit to older factory gauge

PROCEEDS GO TO SUPPORTING THE BOARD - Open to offers

new Fuel Link for matching new fuel sending units with older factory fuel gauge. This unit will convert the fuel sender ohms to match the gauge to make it read accurate again. New was $122.99 never even taken out of original packaging. Item is located in Merrimack NH. Paypal preferred.

$50.00 + shipping

thanks
Rich

MFG. Part #: SN34
Overall Width: 2"
Overall Height: 1.5"
Outside Length: 3"
Info
Put an end to mismatched fuel senders to gauge ohm ranges and erratic movement from fuel slosh with this fuel link interface from Classic Instruments. This fuel link interface allows you to calibrate a custom ohm range (between 0-350 ohms) and has on-board push button with LED readout for calibration. This fuel link interface is compatible with nearly any short sweep fuel gauge and fuel sender combination. The gauge is calibrated at every 1/4 tank reading to ensure accurate readings and the low fuel light is triggered at 1/8 tank. This fuel link interface has a compact design (3" x 2" x 1.5") with under-dash installation mounting holes and has easy screw terminal wire connections. This fuel link interface is proudly made in the USA.

Compatible preset fuel sender ohm ranges (empty to full)

240-33, standard aftermarket
0-90, GM Type 1966 and later
0-30, GM Type 1964 and earlier
16-158, Ford Type 1987 and later
75-10, Ford type 1986 and earlier
90-0, Toyota and Nissan 1985 and later
40-250, Late model GM
10-180 VDO

 

Proceeds go to supporting the board - open to offers