Window felts

Discussion in 'Interior City' started by Red Skylark, Nov 26, 2019.

  1. Red Skylark

    Red Skylark Well-Known Member

    Went to install rear outer window felts on my 71 Skylark. Got the from OPGI. They are not going in correctly. They are gaping at the bend, enough to stick my pinky finger in. Anyone else have trouble? They are the PUI brand that I got. Fronts went in no problem, of course there is no bends.
  2. Red Skylark

    Red Skylark Well-Known Member

    No help, any advice?
  3. LARRY70GS

    LARRY70GS a.k.a. "THE WIZARD"

    I believe I ended up just bending them gently. I think I screwed them in and tapped them with a small rubber mallet. This was many years ago.
  4. gstewart

    gstewart Well-Known Member

    I purchased a set from a dealer in Dallas and they fit perfectly except I had to rebore a couple mounting holes.
  5. Red Skylark

    Red Skylark Well-Known Member

    Thats what I did, drilled a few new holes.
  6. gstewart

    gstewart Well-Known Member

    Ordered from, I think..
  7. Dr. Roger

    Dr. Roger Stock enthusiast

    I have to do some bending to get them to fit the corners better. They bend very easy, so I just use some pipe to bend them around, a little trial and error, and a rubber mallet until they look right.
  8. 87GN_70GS

    87GN_70GS Well-Known Member

    Trivia: identify these 4 GM A body makes, all from 70 20191204_150209.png 20191204_150233.png 20191204_150304.png 20191204_150336.png
  9. Smartin

    Smartin Staff Member

    I use the ones from
  10. Redmanf1

    Redmanf1 Gold Level Contributor

    My guess in order is first one with white top, chevelle , skylark, lemans, cutlass
  11. 87GN_70GS

    87GN_70GS Well-Known Member

    You would be correct. The felt that most vendors sell is from the Chevelle. You will notice it has a slightly different bend than skylark. That is why they dont always fit well

Share This Page