Cole - Can you remove the heater hose clamp from the front right fender well? If so I'd like to buy it. For that matter, how dry rotted are the heater hoses? Zip is 04612
If that is a decklid molding in one of the above pictures I might be intersted pending closer pics of its condition as well. After Maintool-GS (Jim) of course.
Cole: 1. If you still have those 68 parts I said I would buy... 2. Belt reveal moldings- top of both doors- above the door handle and the 2 rear ones. 3. rear window defroster switch, wiring and grate (or will take the whole rear window defrost). More to follow. :beers2:
Cole Not enough of the grille to help me. Thanks for the pic thou. The Wipers. I need the transmissions parts. Specifically, the drivers side, swivel/mount/thing? with the little post on it for the arm, soo when it parks it straitens the blade as it goes down. And the arms, left and rt side plz. Thanks Darrell
Hey yah George How are you?The reveal mouldings are pretty nice I do believe.The rear defog setup is complete from grill to dash switch and everything in between.I will get pictures of it all on Sunday.Let me know if you think of any other bits in the mean time:TU: ...........Cole
Thanks Jim I will let you know when your letter arrives and the speaker ships out,if you think of anything else give me a shout:beers2: ............Cole
Hi Joe,you are right about the board rules,its my bad as well.I did reply to 455nglide through a PM that I looked at before I went to the thread that evening.I then neglected to post that 455nglide had contacted me on it and the intake.Where do we go from here?I' don't think I have 2 #7029244's............Cole
Hi Ken I will pop the clamp off on Sunday and we can see what Jim says on the trunk chrome.Cheers............Cole
Do you have the duct work for the heater? I am looking for the duct work that attaches to the defroster ducts and has the door that distributes the air flow. I would also be interested in the heater control panel if it is in decent shape and if the price is right I might just take the heater ducts all the way to the floor outlet.
Thanks for acknowledging the rule Cole. I suppose it is in place to prevent this very thing. Since you have a package deal including the intake, I say go ahead on the deal with 455nglide. If the pistons look ok I may be interested in them. I need to check my block ('72) to see if it will still accept std bore though.
Hey George here are some picts of the reveal trim(no charge for the extra moss:TU: ) and defogger...........Cole
Right on Joe,again I am sorry for not posting right away and letting this happen.I will check the pistons as I dismantle the engine.I just need the block for a build up I have going:beer ............Cole
Cole, I sent you a PM. Joe;Thanks Again. I have a 69 parts car,if there is any you need let me know....you will be first in line. Best Regards, 455nGLIDE
No worries. I was outbid on the ebay one over the weekend - went too high for a core. I still need a 7029244 (anybody?).
if the complete rear bumper center reverse light assembly is available i would be very interested. shipping area code is 01620 thanks chris
HI COLE, I would be interested in the instrument bezel if all the mount tabs are good. Also the accesary plate and switch if George passes. THANKS BRIAN
