'67 GS Convert part out for a friend

Discussion in 'Car Part-Outs' started by GSX10/10, May 25, 2021.

  1. GSX10/10

    GSX10/10 Well-Known Member

    Posting this for a friend who has a 1967 GS400 Convert that he is willing to sell complete or part out as needed. He owns a restoration shop, so cutting up stuff is not a problem. Car is located in Colorado (north of the Denver metro area). Engine and trans long gone, but still has pretty good sheetmetal left. Was painted at some point and has some body filler in spots, but better sheetmetal than I've seen in a while. The passenger cowel section is pretty destroyed, but the windshield frame is in excellent shape - no rust. Fenders has typical rot, but not too bad and the doors look pretty good too. Same for the quarters. GS hood is gone I believe, but there is a super nice '67 & '66 skylark hood available. Boxed frame looks good with the exception of the rear cross brace - has some weld repair probably due to a trailer hitch, etc.
     
  2. gokitty

    gokitty Platinum Level Contributor

    Interior color ?
     
  3. GSX10/10

    GSX10/10 Well-Known Member

  4. gokitty

    gokitty Platinum Level Contributor

    Looking for a pair of the plastic door jamb end caps.
     
  5. Chuck baxter

    Chuck baxter New Member

    Needing the RH fender moulding that goes below the clamshell. Thanks.
     
  6. GSX10/10

    GSX10/10 Well-Known Member

    I'll check and see if that is still there Chuck
     
  7. Couch

    Couch '67 GS400 Guy

    Is it a power brakes car? Looking for the power brake pedal assembly if so? Thanks
     
  8. 67 Post GS

    67 Post GS Well-Known Member

    looking for both rear wheel well moldings for GS or just right (PASS) side. Thanks Ron
     
  9. Chi-Town67

    Chi-Town67 Gold Level Contributor

    You might want to try contacting "Cole" that's on here, He may have what you're looking for.
     
  10. crazy4my67gs400

    crazy4my67gs400 Active Member

    If this 67 GS is still being parted out I am looking for the trunk hinge torsion bars
     
  11. GSX10/10

    GSX10/10 Well-Known Member

    I think those are still there. I'll send you a PM
     
  12. jcamp116

    jcamp116 Well-Known Member

    Is (was) it a bucket seat car with console? If so, could the rear console mount be cut out and sent?
     
  13. jmg3

    jmg3 Well-Known Member

    if the bucket seats and console are still around I'm interested.
     
  14. Casey Killian

    Casey Killian Active Member

    Any chance the hood scoops and chrome are still available?
     
  15. 67 Post GS

    67 Post GS Well-Known Member

    Interested in wiring harness engine and under dash or all Thanks Ron
     
  16. Are the quarter panels still available?
     
  17. 12lives

    12lives If it runs, it's done!

    PM sent
     

Share This Page