'70-72 BBB Convertible Crossmember

Same for '68-69? Good Cond. Pretty thick on the ends.

Looking for same for SBB (partial trade?).

$285 shipped (lower contiguous 48) or $250 & can deliver to Nationals (or local pickup). Located near Baltimore, MD. PayPal (f&f or add 3%) sdjs1971@yahoo.com. PM w/shipping address, if sending a check, or for Venmo/Zelle payment info.

 

TTT - Can bring to Nationals for less $ (see note in post)

 

How much in the way of rust pitting, especially on each end where covered by the rubber isolation pads?

 

I'll post some close up pics but as far as I remember, it's very nice on the ends.

 

Thanks Dano. Please post a photo of the e-brake cable slot too. The black paint makes it difficult to see it in the photos you already posted.

 

The part number tells that story however no problem Dan. If it didn't have the slot I wouldn't have the note in the OP about looking for an SBB version.

 

Understood.

Actually, between the time I asked about the condition of the ends of the x-member and I posted the "slot photo" request, it dawned on me that the e-brake slot was the only difference between SBB and BBB, and that maybe I should just cut a slot in my SBB x-member and let someone who has a "real" BBB convertible have the correct X-member (even though I'm upgrading to a BBB engine).

I'm still interested in good photos of the ends of your X-member, though.

 

If it's still available, I'll take it.

 

OK by me.

 

Sounds good. Shipping or Nationals?

 

Shipped

 

Sounds good. PayPal the $285 (f&f or add 3%) to sdjs1971@yahoo.com and PM me your shipping address. Thanks.

 

Okay, Will take care of it today.
It will go to: S.D. Lyons, 1898 Fall River Ave, Seekonk, MA, 02771 PM me if you need my cell number.

 

Sold. Thanks.