EDIT/ADD: SOLD...Thank You Original Power Steering Pump from a '70 Skylark. Correct for '70 Skylark/GS350/GS455, etc. >Super clean reservoir/housing inside and outside. Inside is oil free and outside beadblasted bare and sprayed w/a high quality catalyzed satin black paint. This one wasn't dented up and the metal surfaces were very clean prior to my refinishing. >Pump spins freely but I would recommend it be sent off to someone like Power Steering Services in Missouri for a rebuild and re-assembly into the housing. >"A" stamping clearly visible on the face of the housing. >Pump has most associated original hardware - replated zinc lock nut for the pulley, replated studs for the back of the pump and the internal valves, etc that come out when the pump is pulled out. No mounting bolts for the front of the pump or any nuts....easily sourced or I may have some new ones here if someone can post sizes/styles of those (any short bolts or nuts). >Cap for reservoir included (last PIC) - not perfect as it has a couple "rough" areas - could be easily smoothed and painted as these originally were. NOTE: I also have a refinished original pulley for this (350 motor) as well as super nice, correctly phosphated mounting brackets for it (350 motor) along with the 350/455 original aluminum mounting bracket (refinished and very nice. SEE MY OTHER ADS for those. $100 + shipping to the lower 48. PM with your complete shipping address for a total cost. PM for payment options and post interest here on the thread