Any interest in a repro of the plastic battery cable block?

Discussion in 'Repro Parts' started by CJay, Apr 7, 2016.

Page 2 of 2
  1. dl7265

    dl7265 No car then Mopar

    Jason I'm
    Already having this done .. Wish I'd seen ur thread earlier before you wasted your time :X

    DL
     
    dl7265, Apr 17, 2016
    #21
  2. CJay

    CJay Supercar owner Staff Member

    I hate when that happens! What point are you at with it? And what material did you go with?
     
    CJay, Apr 17, 2016
    #22
  3. dl7265

    dl7265 No car then Mopar

    PM you . Thx


    Sent from my iPhone using Tapatalk
     
    dl7265, Apr 17, 2016
    #23
  4. dl7265

    dl7265 No car then Mopar

    Clean box out please ;)


    Sent from my iPhone using Tapatalk
     
    dl7265, Apr 21, 2016
    #24
  5. CJay

    CJay Supercar owner Staff Member

    Made some room Don, PM away
     
    CJay, Apr 21, 2016
    #25
  6. BUQUICK

    BUQUICK I'm your huckleberry.


    Well it looks like three guys are making these now. Another board member sent my dad a photo of the reproduction that he has already made using a 3D printer. I'll direct him to this thread.
     
    BUQUICK, Apr 22, 2016
    #26
  7. Buicksky

    Buicksky Gold Level Contributor

    I would be interested in one if a split unit. Tony
     
    Buicksky, Apr 22, 2016
    #27
  8. CJay

    CJay Supercar owner Staff Member

    Update- Here is my two piece prototype. Fits very nice and snug on my original battery cable. The finish is matte black and has a slight texture to it. So far so good. Next is to get it mounted in the car for thermal testing. Its really hard to take a picture of it. Might have to take some pics in the daylight tomorrow.

    20160426_201351[1].jpg 20160426_201453[1].jpg
     
    CJay, Apr 26, 2016
    #28
  9. dl7265

    dl7265 No car then Mopar

    Jason
    Proceeding with duplication of same part ?


    Sent from my iPhone using Tapatalk
     
    dl7265, Apr 27, 2016
    #29
  10. CJay

    CJay Supercar owner Staff Member

    The prototype part was already in the works when I found out. At this point, Im going to proceed with installing it and testing it. Once that's done, I'll see where everyone is at with this.
     
    CJay, Apr 27, 2016
    #30
  11. rtv72

    rtv72 Founders Club Member

    Looks nice Jason! Still interested!

    Ron
     
    rtv72, Apr 27, 2016
    #31
  12. 1972 Stage 1

    1972 Stage 1 Well-Known Member

    I'll buy one from all three of you to keep the peace! :laugh:

    Looks good Jason!
     
    1972 Stage 1, May 1, 2016
    #32
  13. Xporcelli

    Xporcelli Gold Level Contributor

    I'm ready for one now if anyone has one for purchase. I can give feed back on fitment with my new repro engine harness. PM me if you can help. Thanks-Scott
     
    Xporcelli, May 18, 2016
    #33
Page 2 of 2

Share This Page