> shipping extra if needed #80531 holley , 850 cfm vacuum secondary , electric choke carb . good sized carb for a stockish big block in a heavier vehicle - mid size or full size with automatic trans mainly . new at summit racing these are $670+ . paid a little more for it , looked clean , nice and complete . disassembled and inspected . looked great inside also . it got a bath n flush , no refinish needed , checked gasket surfaces etc , polished up little stuff as i went along . reassembled using correct kit n parts . oem spec parts . plus - mod'd nozzle screw for a little better flow , one of the top vents was a little wanged up so i added extended bowl vents , added power valve protection , added quick lid vac secondary kit , new bowl bolts and correct power valve #'s . vac secondary bench tested good . test run , started good , kinda too much for my stockish 360 but 10 mile road test was good . drained , cleaned . please check pics and info carefully contact me if you have any questions thanks for the look -------------------------------- needle/seats - .110 front jets - 78 rear jets - 82 front metering block - 11981 rear metering block - 11697 power valves - 4.5 fr / 3.5 rr pump nozzle - 40 acc pump - 30cc pump cam - 330/pink vac sec spring - purple ( oem is listed as "pink" ? no info on that . installed purple - good step up from normal plain spring ) above are all oem spec parts except where noted ------------------------------- throttle plates and floats set at oem spec idle screws set at 1.0 full turns out as a start up point 5.5 - 6.5 lbs fuel pressure per holley tech i recommend non ethanol fuel and/or an additive such as seafoam or stabil mounting bolts - 12-14 lb ft max -------------------------------- $350.00
ok , quick check - ups ground and usps priority . no easy fed ex pickup for me . others are just easy drop offs . ups with insurance was almost $30 . i get a ups deal so maybe a couple bucks cheaper ? postal was $20+ , not inc insurance so probably $27-$28 . same pretty much . guesstimate on box size etc so would need to box 'er up and get accurate quote . but that should be real close .