https://www.millsupply.com/auto-bod...-buick-skylark-rear-quarter-panel-687050l.php I pretty much muffed the trunk floor by leaving rubber mats in there and it pretty much disintegrating. The quarters are pretty rough, One side had the marking of a bought with a guard rail and the pass side is full of bondo( I bought it like this in 85). I've been watching John Green on facebook do up his GS455 4 spd car and kinda have the idea Id like to get mine up and running one of these days. I've read that the amd stuff is good but they don't have anything on their website. So, off to google I went. I found this mill supply place. Anyone have thoughts or experience with this place before I lay out about $1500 to get the parts and have them shipped, truck freight none the less, so It isn't cheap. Thanx for any input.
So first off those aren't full quarters, which I just bought a RH of one of those and a full quarter for the LH side. After receiving both it was clear the full quarter was much better quality IMO. The wheel opening on the 80% quarter wasn't as nice . So I took back the 80% quarter and got the full for the RH side. Got it through the Parts Place Inc in Dekalb IL they shipped the parts to house but I was going on a trip so I drove the part out there for the return. I think you will be happier with full quarter even if you don't use the whole panel.
The parts place has the AMD stuff and the trunk floor from AMD on their site is listed under Chevelle. It is the same for 1970, except for the tail section, which has to be reused and seamed in at the rear brace - not too bad to do. I have photos of this on my restoration thread for the burgundy mist car.
