soaking wet behind the ears! could use some help here.

so im both hew to the form and building a custom car. or at least a custom old car, especially one that has a pretty limited parts market! this car will be my daily driver after a fix the rust in the trunk and slap inspection stickers on it. this being said im looking to do a few things ere to make it a little more dependable on the road, im looking to do disk brakes in the front, and ive found quite a few kits online for it but non off them are listed as specifically Buick lesabre parts. not this dose not concern me much because they are listed as 'GM B body' but this being said will most or any 65-70 B body parts fit? most of the work im planning on doing has to do with the suspention and making it handle very well and maybe turning it into a "canyon carver"

 

www.scarebird.com

 

ive been to that sight and was trying to see if they would work with 2 inch drop spindles, or if those work with Wilwood 2 piston calipers.

 

I suspect that you are talking about uncharted territory.

 

Welcome aboard. Hopefully someone has already been where you want to go and can help you out.
Fred

 

well then i will boldly go into the un-explored world of road race modifications i guess. ill be sure to keep everyoneupdated.