I'm in need of 5 of the clips (offset studs) that hold the console trim on and the 2 end pieces that cover the ends of the side pieces. They were missing after I got my trim back from the polisher and now he has passed away. So anyone having these or knowing where to get some would be much appreciated to complete my console restoration. Thanks, Bryan
The end caps, called escutcheons, are also held in place with the offset studs. So, would you also need offset studs for those, too? Would you need nuts for all, as well?
I would need the escutcheons and 5 offset studs if they are all the same. If they're different 2 for the escutcheons and 3 for the side moldings. I have all the nuts so I do not need any. Would you have any clips for the molding at the bottom edge of the the trunk lid also. 2 of them turned up missing as well. Thanks, Bryan
That's fine. Thanks again Matt. Just let me know what you have, the cost, and payment method you prefer. Thanks, Bryan
I'm pretty sure I have all the stuff you need. Can you post a picture of the rear trim clips. I just want to be certain that the ones I have are the ones you need. Will you need the short screws , too? Thanks, Matt
OK Matt will do tomorrow for rear clip and I will check the quantity of each that I will need. Thanks, Bryan
Yes Sir right on point. I sent you some pics yesterday in a reply email. They look the same as the pics you posted. So I would 2 trunks molding clips and screws plus the clips and escutcheons for the console we spoke about already. Shoot me a price with shipping and payment method Paypal, etc. Thanks, Bryan
Sorry, I was so excited about finding these damn clips/screws I left out a word or two in my previous reply. "I would NEED 2 trunk molding clips and screws plus the clips and escutcheons for the console we spoke about already. Shoot me a price with shipping and payment method Paypal, etc. Thanks again, Bryan
Matt do you have all the clips and escutcheons and were you able to come up with a total cost with shipping so I can pay you? Thanks, Bryan
Matt were you able to come up with a total cost for the console parts, trunk molding clips/screws, and payment method? I'm ready when you are. Thanks, Bryan
Bryan, Yes, I will figure that out this evening or tomorrow morning - latest. I'll PM you. Please forward your shipping info. Thanks
Matt again I thank you. I am in need of one more thing at the moment. Would you have the window gasket rail front stainless corners at the top where the rail meets the A pillar? Mine is cracked and missing the rubber piece. I think I need the driver side, but if you had both i would take them. These are not the drip rail corners, but the gasket rail corners.
Bryan, I have none of those used. I do have one nos, but, I wouldn't even begin to know where it is and I don't know what side it's for. Best to start another wanted post. Every two door HT had them so should not be difficult to find. Matt
Bryan, I tried to send these parts to you via U.S. Postal Service in an effort to save you some money, however, the P. O. has become the most worthless P.O.S. PITA to use for sending things. I may repackage the parts into a padded envelope or have to use UPS. I will let you know . Hopefully I will have them to you early next week. Matt
Parts shipped to you via USPS 1st Class mail. Should be at your place in a few days at most. Sending PM