X Member

Discussion in 'The "Juice Box"' started by Elliott, May 14, 2010.

  1. Elliott

    Elliott Active Member

    Hope that I am in the right area for this post. A few months ago I posted about T/a frame pads about the off set . The fast response solved my problem.This is my new problem. I put a 455motor into my 1966 skylark convertible with a 400 tranny motor and tranny went in easily. The problem that I am having the x member from the original drive train which was a 300
    with a two speed tranny is not lining up it hits the transmission pan. This is
    driving me nuts. Is it possible that I need a different type of x member.

    Thanks in advance.
    Elliott
     
  2. 12lives

    12lives Control the controllable, let the rest go

    You should be able to move the crossmember back. Look at the frame and there should be extra holes in the side rails.
    - Bill
     

Share This Page