I am looking for a LF door and LR quarter molding for a 64 Skylark. these would be the painted silver center. would like dent -free ,needing paint is ok. another member is checking on the door molding , If possible I would like to save shpg and get them from one location,, Wacko ---------- Post added at 09:08 AM ---------- Previous post was at 09:06 AM ---------- this is convertible or ht moldings
I am sure I have one. I know they are different right to left but I cant remember how to tell. Do you have the horseshoe around the right (passenger side) taillight?
Gary, There are no difference for 1964 skylark door wide moldings. Both sides are the same from what I can tell. On the narrower special moldings there is a water drain notch on the moldings. The 2 I have one is better than the other and the dings look to be in the center where they get painted. one of them may have a ding on an edge but not noticebale. I'll sell one or both to you for $40 + shipping and you can pick the better of the 2 and sell the other. Let me know. Thanks. Brian
Just an observation, but there is a difference in L&R door moldings. They have a slight curve to them that follows the curve of the rest of the side moldings. Looking down the side of car you can see the door and rear quarter moldings have a gentle down ward sweep. Also the end of door molding at front fenders has a slight angle that is shorter on top side. Fender moldings have the same sweep to them and end at door has angle that mirrors door moldings. Of course the fender moldings have part # and L/R on back side. Hope this is some help.
There is a difference in the quarter panel trim. You will notice it if you try to put the wrong one on. Also the doors are different and you can see it at the ends that taper different as stated. Did you get your part yet?
I have not found these yet. The left moldings are different from the right. If you have these let me know how much with shpg to 04257, Maine, Thanks, Gary