The part number is 3826S with an "A5" under the part number. $25.00 plus the cost of shipping inside of a USPS large Flat Rate mailer ($14.50 for shipping unless the fee went up at the post office in which case the increased price will pass along to the customer). I tried to use the medium flat rate box but the throttle linkage was too long for the smaller container. Because of the age of this item I make no promises but with a new kit it will probably function just fine. This is from one of my previous postings which is available via this link where numerous photos of the item are available. Still only $25.00! If you have one of those rare 1965 cast iron 300 intakes, this is the carb that you need for OEM restoration. http://www.v8buick.com/showthread.php?t=199629 Alan R. Broadbent 2700 Oklahoma Street West Melbourne FL 32904 (321) 427-3070 abroadbent@bellsouth.net
I will have to look it over and will let you know what kind of shape it is in. I just pulled it out of storage. It will be tomorrow before I get to it - just got out of the shower... Did you get the chance to look at the photos from that distant listing that I had back on 03/07/2010? Plenty of photos of the part. Al Broadbent
I just checked it out and the priary butterflies function freely but I did not get the back oes to move - possibly something that I was not doing correctly. I think I took photos a while back showing these were fully open but not sure. If you still want the carburetor let me know. I can do a personal check, Postal Money Order of Paypal providing the fees are covered. One of these sold on Ebay for $46.00 plus $17.90 shipping so this is pretty cheap for the same item. Here's a link to the completed auction: http://cgi.ebay.com/ebaymotors/Cart...r_Truck_Parts_Accessories&hash=item35b0a34a43 Here's a link to my vintage post of this carb in 2010 with all the photos: http://www.v8buick.com/showthread.php?t=199629 My PN box is pretty near full so if you need to contact me you can do so via my email address: abroadbent@bellsouth.net
