I have a matching numbers SP motor and turbo 350 trans completely rebuilt. Motor has already been broken in. Carb to pan,water pump to trans. Customer has decided to go with 455 conversion. All rebuilt to original specs except for mild Comp Cam. (#92-202-4 .454/.454 dur @ .50 212/212 110 c/l grind # B350 260H-10). Set up is in Florida. Can be brought north if needed. 1500.00
Was this just a refresh rebuild or did you have to bore the cylinders some. What was done to the heads? Did you run it on a Dyno and get any numbers? Transmission get a full rebuild and does it have stock converter? Thanks Matt
Cylinders checked out fine,only needed a hone. Heads were completely gone thru, 3 angle valve job, bronze valve guides. Motor was not Dynoed. Trans was rebuilt to stock specs,comes with convertor.
Break in time was about an hour. Was started on a stand. Package is located in Florida,I can get some pics to post. Might take a day or 2. Thanks for looking.
Alan, I just asked for pics should have them to you by Weds afternoon. What email can they be sent to? Located in South Florida,Pompano Beach. He also makes runs along 95 to 26 to 77 up here to Cleveland about every 2-3 months.
Ok Alan, I have not heard from you either PM or Reply since Weds. Scott you are up! Bob you are next if Scott passes. Thanks