The part number for the 64-69 Olds Cutlass/F-85/442 3/4speed shifter hump is 4536068. It's listed in the parts book in Group 12.980 and refered to as "COVER, floor pan transmission". I have a Buick parts book but it only goes up to 1967, if someone has a Buick parts book they can look it up in the same group number and see if the part number is the same. Henry
I will also check the Stamped number in the corner of the 2 1968 442s at my buddys land...Because these numbers don't corespond with any numbers in any of my assembly manuals or chasssis manuals.. So I think they designate something else and not a prt number...I will get back to you guys.. Randy
It actually looks the same.. They probably just bent them a little different at the factory.. Is there a number in the upper right corner of the hump??
Floor Shift Ring Just looked up the part # in my master pts book: Group 12.980, Part# 4438249, Cover, Floor Pan Trans for a 65 3 or 4 speed. Hope this helps. :TU: Al
I got back to work on this yesturday.. Should be ready to go by monday..I have both humps almost ready.. So I need someone to send me a ring so Shane can reproduce that also.. PLEASE HELP!! I can give the ring back right away if some bady wants me to.. I will just pound ot a reprodution and make sure it fits the same.. Thankyou!!
update Here is my work.. Now I will wait to make sure the ring fits and replicate a couple of them and sent them off to the parts place.. :TU:
Looks like your making some good headway on this Randy. Hats off to you and your hard work. I can't wait for TPP to finish them.
Here is your ring on my buick hump.. Bent a little more but all the holes line up exactly.. :Smarty: This will work on either.. And remember I replaced a small piece in this one on the bottem where the other one I had was complete.. :TU: