I need .030 Pistons Hyper or forged doesnt matter. Cam- I am lookin for a radical cam as a kit or individual Heads- Anything that would be better than the 76 heads on it now. Mounts- Motor mounts to drop in an 85 regal Intake- Im told the B4B is a daisy but maybe you got something else??? or any other performance tricks you may know to squeeze power out...I am lookin at high 11s low 12s and my other goal is to have around 12-1 compression if possible Time to clean out your garage and get rid of your old parts.
Waterboxguy03 Hi,I have a short block built by Jim Burek of Texas.The pistons are 60/over, everything is still togheter.The block is filled.It has never run.its been in my garage for a few years.Interested in anything?BrunoD.
Radical Cam I have a Poston 105 cam with the lifters. The duration is 332 intake and 332 exhaust. Lift is 554 with a 105 lobe center. Requires notched pistons. I ran a best of 11.02 at 123mph with this cam The lifters have been packaged and marked to go back on the same lobes they were run on. This is important otherwise you could flatten the cam. I also have a GSCA cam and lifters. Its more of a street strip cam. Doesn't require notched pistons but it never hurts to check. Will sell cam and lifters either cam for $ 125.00 I can be reached at 775 727 4910 in Pahrump NV or e-mail me rmstg2@usintouch.com................Thanks Bob H.
I have a set of used .030 hyper aluminums I have these for sale, not many hours on them. $120.00 plus S&H. If you're interested I can post some pics.
Cam Check with your piston man they might be notched. You know someone from they old school they could show you how to notch your pistons but its kinda primitive and slow. Your best bet is to buy them already notched. The 105 has about 40 passes on it still looks good. I changed oil every time I took the car to the track to eliminate any fuel contamination. The club cam was only broke in and pulled from the engine its like new and it will get you into the 12s for sure if every thing else is right
GSCA Cam The club cam how did it sound? What kinda build did you have it in to run 12s?? Im going to try calling tonight sometime.
Club Cam Do you have the specs on the club cam? Whyd you take it out? Any other info you could tell me would be great. Thanks Justin
pistons Go ahead and sell them to the other guy Im waiting for some numbers Im not sure whether I want forged of hypers yet.
Radical Cam Ok after talkin to my dad he said to look more to the bigger cam. About the notched pistons when you had this in your motor whered you get your pistons? were they a special order or something I could call up TA or Poston and get? How much are a set of forged notched pistons? If you could get the exact numbers for this cam id appreciate it. Hang with me here its my first 455 so I gotta do my research. Thanks again Justin
