455 Dyno'd today & I am horrified!!

Through 8 pulls we’re at 391hp & closer to 500 lb. ft.

Getting there.

Kyle

 

The first pull wasn't a pull then they were just loading it a little surprised they didn't make that clear tho

 

I recently Built a Stage 1 iron head & similar same intake and exhaust cam was on 112cl .

The compression was 9.5-1 all the rest bone Stock 4 speed 70 carb ,iron intake , etc with exception of headers .
On the Dyno it made 395 at 5500 34 degrees . 93 octane . Don’t remember Tq .

Hugger was on the money .

I would say your right where you need to be .

I have not had one cam from TA , comp or lunati that I could get to come at 0 . Usually all are 4-6 advanced .

You guys should have CC calculated the volume of piston , deck height volume with piston at TDC & CC head chamber . Otherwise I bet your closer to 9-9.7-1 . So that’s close to 10.0-1 lol .thars with 040 felpro gasket

 

Kyle - read the thread from Larry on power timing.